Festo Контроллер позиционирования CPX-CMAX - Manual (Page 85)

3. Drive functions
3−23
Festo P.BE−CPX−CMA X−CONTROL−EN en 0908NH
Regarding Fig. 3/6:
1 to 3: Setpoint value and actual value curves. The setpoint
value here refers to the reference setpoint value which is genĆ
erated by the trajectory planning.
4 to 6: Enlarged illustration of the control fault and the two
tolerances. The following error tolerance (11 mm) is much
greater than the positioning tolerance (0.1 to 10 mm or 0.004
to 0.394 in).
7: The MC signal determines which tolerance is used.
Overview of parameters involved (see section 5.4.6)
Parameters involved Description PNU
Position control Target setpoint value: Target position 300:02
Output of the reference setpoint value generator − position ć 1)
Actual value: Actual position 300:01
Current deviation: Position deviation 300:03
Following error tolerance (fixed: 11 mm or 0.43 in) ć
Positioning tolerance 411:xx or
545
Force control Target setpoint value: Target force 301:02
Output of the reference setpoint value generator − force ć 1)
Actual value: Actual force 301:01
Force deviation 301:03
Following error tolerance (fixed: 5 N or 1.12 lbf ) ć
Force tolerance 411:xx
or 552
1) No parameter defined, but available in trace
Tab. 3/8: Involved following error or tolerance monitoring parameters