Festo Контроллер позиционирования CPX-CMAX - Manual (Page 429)

C. Configuration with CPX node
C−31
Festo P.BE−CPX−CMA X−CONTROL−EN en 0908NH
Fig. C/15: Idle mode parametrisation for example Tab. C/9
In order for the settings to take effect, the global system
parameter must be set to Use idle mode".
C.3.3 Save actual configuration as the nominal configuration
In order to save the changes permanently, after the changes:
ć the actual configuration must be saved as the nominal
configuration,
ć or the project must be loaded into the CPX−FEC (a proĆ
gram must exist for this).
Note
Make sure that you have supplied taught parameters, or
parameters edited via the keyboard or the CPX−MMI, to the
CPX configurator.