Festo Контроллер позиционирования CPX-CMAX - Manual (Page 327)

A. Notes on commissioning and service
A−19
Festo P.BE−CPX−CMA X−CONTROL−EN en 0908NH
Parameters Permissible deviations for nominal/actual comparison
Prior to transfer of SN 1) After transfer of SN 2) After identification
Cylinder
Type no deviation no deviation no deviation
Nominal/effective
length
3)
5 mm 5 mm 5 mm
Diameter no deviation no deviation no deviation
PR diameter 4) no deviation no deviation no deviation
Measuring system
Type no deviation no deviation no deviation
Nominal length 5 mm 5 mm 5 mm
Serial number any changes any changes 5) any changes 5)
Valve
Type no deviation no deviation no deviation
Serial number any changes no deviation no deviation
1) Prior to transfer of the serial numbers any changes to the setpoint configuration are permissible if
there is no actual configuration. A complete actual configuration is currently only available when
using the DGCI.
2) After transfer of the SN or the identification, these tolerances not only apply to variations between
the setpoint values and actual values, but also between old and new setpoint values.
3) Only a cylinder length to which both actual values are compared is projected.
4) Piston rod diameter
5) No deviation permissible with the DGCI.
Tab. A/2: Permissible deviations for nominal/actual comparison
Optimize parameters
Various parameters can still be modified after commissioning
in order to optimize the project. The cylinder length can, for
example, be modified by up to 5.00 mm in order to be able to
move right up to cylinder end position with force control.