Festo Контроллер позиционирования CPX-CMAX - Manual (Page 11)

Contents and general safety instructions
IX
Festo P.BE−CPX−CMA X−CONTROL−EN en 0908NH
Intended use
This description contains the communication profile for the
axis controller type CPX−CMAX−C1−1. The profile is based on
the Festo Handling and Positioning Profile (FHPP).
This provides you with supplementary information about conĆ
trolling, diagnosing and parameterising the axis controller via
the fieldbus.
Additional information can be found in the system description
for the used axis controller (see Tab. 0/1):
ć Description P.BE−CPX−CMAX−SYS−...:
Mounting, installation, positioning system diagnostics
Note
Make sure you observe the safety instructions given in the
system description.
General basic information on the mode of operation, on
mounting, installing and commissioning CPX terminals can be
found in the CPX system description, type P.BE−CPX−SYS−... .
General information about the used CPX node can be found in
the associated description:
ć Description type P.BE−CPX−FB...−.../P.BE−CPX−PNIO−...:
Description of the respective CPX node.
ć Manual type P.BE−CPX−FEC−...:
Description of the CPX Front End Controller.
Appendix C of this description contains additional information
on how to use the CMAX with supported fieldbus nodes.