Festo Контроллер позиционирования CPX-CMAX - Manual (Page 317)

A. Notes on commissioning and service
A−9
Festo P.BE−CPX−CMA X−CONTROL−EN en 0908NH
Commissioning errors
Fig. A/1 only shows the most impor tant paths, to explain the
principle.
If only one component is found, for example (sensor or valve),
error E60 or E80 is generated, since it can be assumed that
this point to a defect. Apart from that, there are also other
possible errors prior to or during commissioning, e.g.
ć insufficient operating voltage E52,
ć memory error E7x,
ć controller enable before reaching status C03
(causes E05).
More information on the status display can be found in the
CMAX system description (Chapter 5).