Festo Контроллер позиционирования CPX-CMAX - Manual (Page 329)

A. Notes on commissioning and service
A−21
Festo P.BE−CPX−CMA X−CONTROL−EN en 0908NH
A.3.2 Exchanging components
Nominal/actual comparison of the hardware configuration
With each new calculation of the controller, a nominal/actual
comparison between the current hardware configuration
(actual configuration) and the setpoint configuration is perĆ
formed.
Setpoint configuration The setpoint configuration consists of the values for the
drive configuration parametrised by the user.
Actual configuration The actual configuration consists of values for the hardware
components ascertained during the automatic hardware
recognition.
Exchange of a component
The CMAX identifies an exchange as specified in Tab. A/4.
Component Component exchanged for component ...
of the same type and size of another type or size
Cylinder/drive DGCI: Recognition based on serial
number of the measuring system DGCI: Recognition based on length and
diameter information in the measuring
system
Other drives: recognition not possible Other drives: recognition not possible
Valve Recognition based on serial number Recognition based on type information
Measuring system DGCI: Recognition based on serial
number DGCI: Recognition based on length and
diameter information
Other measuring systems: recognition
not possible Other measuring systems: recognition
of the design based on sensor interĆ
face, no length information.
Sensor interface Recognition based on serial number Recognition based on type information
Tab. A/4: Exchange of a component − recognition by the CMAX