PLANET XGS3-24042 - Manual (Page 989)

49-7
Examples:
Display the number of dynamic ARP of the port and VLAN which are configured with number
limitation function of ARP.
Switch(config)# show arp-dynamic count interface ethernet 1/0/3
Port MaxCount CurrentCount
-----------------------------------------------------------------------------------------------------
Ethernet1/0/3 5 1
-----------------------------------------------------------------------------------------------------
Switch(config)# show arp-dynamic count vlan 1
Vlan MaxCount CurrentCount
-----------------------------------------------------------------------------------------------------
1 55 15
-----------------------------------------------------------------------------------------------------
49.11 show mac-address dynamic count
Command:
show mac-address dynamic count { (vlan <1-4096>)| interface ethernet }
Function:
Display the number of dynamic MAC of corresponding port and VLAN.
Parameters:
<vlan-id> display the specified VLAN ID.
is the name of layer-2 port.
Command Mode:
Admin and Configuration Mode
Usage Guide:
Use this command to display the number of dynamic MAC of corresponding port and VLAN.
Examples:
Display the number of dynamic MAC of the port and VLAN which are configured with number
limitation function of MAC.
Switch(config)# show mac-address dynamic count interface ethernet 1/0/3
Port MaxCount CurrentCount
-----------------------------------------------------------------------------------------------------
Ethernet1/0/3 5 1
-----------------------------------------------------------------------------------------------------
Switch(config)# show mac-address dynamic count vlan 1