PLANET XGS3-24042 - Manual (Page 1177)

75-7
75.5 show mpls enable
Command:
show mpls enable
Function:
Display whether the mpls is enabled.
Command Mode:
Admin and Config mode.
Usage Guide:
Implementing this command will display whether the mpls is enabled.
Example:
Display whether the mpls is enabled.
Switch#show mpls enable
Switch#MPLS enable has been on
Related Commands:
mpls enable
75.6 show mpls forwarding-table
Command:
show mpls forwarding-table
Function:
Display the information of all LSP created by the switch as an ingress router, and FTN (FEC to
Next-Hop-Label-Forwarding-Entry) marked as selected.
Command Mode:
Admin and Config mode.
Usage Guide:
Implementing this command will display the information of all LSP created by the switch as an
ingress router, and FTN marked as selected.
Example:
Display the information of all LSP created by the switch as an ingress router.
Switch#show mpls forwarding-table
Codes: > - selected FTN, B - BGP FTN, C - CR-LDP FTN, K - CLI FTN,
L - LDP FTN, R - RSVP-TE FTN, S - SNMP FTN, U - unknown FTN
Code FEC FTN-ID Pri Nexthop Out-Label Out-Intf
L> 200.200.1.2/32 1 Yes 202.200.1.1 640 Vlan3