PLANET XGS3-24042 - Manual (Page 541)

34-180
no router ipv6 rip
Function:
Enable RIPng routing process and entering RIPng mode; the “no router ipv6 rip” of this command
disables the RIPng routing protocol.
Default:
RIPng routing not running.
Command Mode:
Global mode
Usage Guide:
This command is for enabling the RIPng routing protocol, this command should be enabled before
performing other global configuration of the RIPng protocol.
Example:
Enable the RIPng protocol mode.
Switch(config)#router ipv6 rip
34.19 show debugging ipv6 rip
Command:
show debugging ipv6 rip
Function:
Show RIPng debugging status for following debugging options: nsm debugging, RIPng event
debugging, RIPng packet debugging and RIPng nsm debugging.
Command Mode:
Admin mode
Example:
Switch#show debugging ipv6 rip
RIPng debugging status:
RIPng event debugging is on
RIPng packet detail debugging is on
RIPng NSM debugging is on
34.20 show ipv6 rip interface
Command:
show ipv6 rip interface