PLANET XGS3-24042 - Manual (Page 1232)

77-8
ip vrf forwarding <vrfName>
no ip vrf forwarding <vrfName>
Function:
Bind interfaces to the specified VRF.
Parameters:
> is the VRF name, a string shorter than 32 characters.
Command Mode:
Interface Configuration Mode.
Usage Guide:
Implementing the command if the interface needs to access the Internet. Each interface can only be
bound to one VRF, while the latter can be bounded with multiple interfaces. The IGP supporting
VPN will record the binding relationship between interfaces and VRF by adding a route received
from the bound interface to the route table of the bound VRF. By default, the interface is bound to no
VRF, and is a public network interface.
Example:
Switch(config)#int vlan 9
Switch(Config-if-Vlan9)#ip vrf forwarding vpn1
77.13 mpls proxy loopback-group
Command:
mpls proxy loopback-group <1-max_agg_num>
no mpls proxy loopback-group
Function:
Make the boardcard to implement MPLS function through MPLS proxy.
Parameter:
<1-max_agg_num> is loopback group ID, ranging from 1 to 128.
Default:
Do not enable MPLS proxy.
Command Mode:
Interface Mode
Usage Guide:
When the port of VLAN on the boardcard which does not support MPLS, the interface bind VRF or
configure the label exchange, to implement MPLS function, it must configure a loopback group, at
least one port (Note: the added port must be not used by vlan1) of the boardcard which support
MPLS is added to loopback group, configure MPLS proxy on the interface.
Example 1: