PLANET XGS3-24042 - Manual (Page 1119)

67-3
default value.
Parameter:
is the value of the length with a value range of 500-1470.
Command Mode:
Port Mode.
Default:
The value is 1400 by default.
Usage Guide:
When combining several samples to a sFlow group to be sent, the length of the group excluding the
MAC head and IP head parts should not exceed the configured value.
Example:
Configure the max length of the sFlow packet data to 1000.
switch (Config-If-Ethernet1/0/2)#sflow data-len 1000
67.5 sflow destination
Command:
sflow destination <collector-address> [<collector-port>]
no sflow destination
Function:
Configure the IP address and port number of the host on which the sFlow analysis software is
installed. If the port has been configured with IP address, the port configuration will be applied, or
else the global configuration will be applied. The “no” form of this command restores the port to
default and deletes the IP address.
Parameter:
is the IP address of the analyzer, shown in dotted decimal notation.
<collector-port> is the destination port of the sent sFlow packets.
Command Mode:
Global Mode and Port Mode.
Default:
The destination port of the sFlow packet is defaulted at 6343, and the analyzer has no default
address.
Usage Guide:
If the analyzer address is configured at Port Mode, this IP address and port configured at Port Mode
will be applied when sending the sample packet. Or else the address and port configured at global
mode will be applied. The analyzer address should be configured to let the sFlow sample proxy
work properly.