PLANET XGS3-24042 - Manual (Page 670)

37-309
Switch (config)#router bgp 100
Switch(config-router)#address-family ipv4 vrf DC1
Switch(config-router-af)# neighbor 11.1.1.64 remote 200
Switch(config-router-af)# neighbor 11.1.1.64 soo 100.100:10
After this attribute set, the switch will no longer spreads the route with 100.100:10 rt attribute to
11.1.1.64. (what have to be mentioned here is that the soo attribute will be judged together with
other rt attributes, which means if the rt is configured with the same attribute, it will be regarded as
the origin neighbor even if it’s not the real origin source. As a matter of fact, the normal configured
soo are a single configuration which is different from rt/rd and unique within the accessible scope. In
this way can only the origin concept be exactly expressed).
37.75 neighbor strict-capability-match
Command:
neighbor {|} strict-capability-match
no neighbor {|} strict-capability-match
Function:
Configure whether strict capability match is required when establishing connections. The “no
neighbor {|} strict-capability-match” command set to not requiring strict
match.
Parameter:
: Neighbor IP address
: Name of peer group
Default:
No strict capability match configured.
Command Mode:
BGP route mode and address-family mode
Usage Guide:
This command takes effect to MP-BGP only. With this command, neighbor can be established when
MP-BGP capablilities of the both side are matched, or else it can not be establised. However,
whether other capablilities are matched will not affect to establish neighbor.
Example:
Switch(config-router)#neighbor 10.1.1.64 strict-capability-match