PLANET XGS3-24042 - Manual (Page 841)

44-116
Default:
Enable the function.
Usage Guide:
After enable vlan snooping in global mode, input this command to configure the maximum query
response time of the specific group.
Example:
Configure/cancel the specific-query-mrsp of vlan3 as 2s.
Swith(config)#ip igmp snooping vlan 3 specific-query-mrsp 2
Swith(config)#no ip igmp snooping vlan 3 specific-query-mrspt
44.10.20 ip igmp snooping vlan static-group
Command:
ip igmp snooping vlan static-group [source ] interface
[ethernet | port-channel]
no ip igmp snooping vlan static-group [source ]interface
[ethernet | port-channel]
Function:
Configure static-group on specified port of the VLAN. The no form of the command cancels this
configuration.
Parameter:
vlan-id: ranging between <1-4094>
A.B.C.D: the address of group or source
ethernet: Name of Ethernet port
port-channel: Port aggregation
ifname: Name of interface
Command Mode:
Global mode
Default:
No configuration by default.
Usage Guide:
When a group is a static while also a dynamic group, it should be taken as a static group. Deleting
static group can only be realized by the no form of the command.
Example:
Switch(config)#ip igmp snooping vlan 1 static-group 224.1.1.1 source 192.168.1.1 interface
ethernet 1/0/1