PLANET XGS3-24042 - Manual (Page 160)

8-6
interval whenever the Remote Table changes.
Example:
Set the time interval of sending Trap messages as 20 seconds.
Switch(config)# lldp notification interval 20
8.10 lldp tooManyNeighbors
Command:
lldp tooManyNeighbors {discard|delete}
Function:
Set which operation will be done when the Remote Table is full.
Parameters:
discard: discard the current message.
delete: Delete the message with the least TTL in the Remoter Table.
Default:
Discard.
Command Mode:
Port Configuration Mode.
Usage Guide:
When the Remote MIB is full, Discard means to discard the received message; Delete means to the
message with the least TTL in the Remoter Table.
Example:
Set port ethernet 1/0/5 of the switch as delete.
Switch(config)#in ethernet 1/0/5
Switch(Config-if-ethernet 1/0/5)# lldp tooManyNeighbors delete
8.11 lldp transmit delay
Command:
lldp transmit delay <seconds>
no lldp transmit delay
Function:
Since local information might change frequently because of the variability of the network
environment, there could be many update messages sent in a short time. So a delay is required to
guarantee an accurate statistics of local information.