PLANET XGS3-24042 - Manual (Page 1201)

76-19
76.30 ldp keepalive-timeout
Command:
ldp keepalive-timeout <time-val>
no ldp keepalive-timeout
Function:
Configure the session timeout value of the interface; the no operation will restore the default value.
Parameters:
is the timeout value of sessions, ranging from 1 to 65535 seconds.
Default:
30s.
Command Mode:
LDP Protocol Configuration Mode
Usage Guide:
LDP will send keepalive messages to each other for keeping the communication, if there is no data
after the creation of a TCP session. Without receiving a keepalive message within the timeout
period set by this command, the connection will be treated as disconnected. Usually this value
should be at least three times as long as the keepalive interval. Parameters different with the label
configuration can be used when configuring the interface.
Example:
Configure the keepalive-interval of the interface as 200s.
Switch(config)#int vlan 9
Switch(Config-if-Vlan9)#ldp keepalive-timeout 200
Related Commands:
ldp keepalive-interval, keepalive-interval
76.31 ldp label-retention-mode
Command:
ldp label-retention-mode {conservative | liberal}
no ldp label-retention-mode {conservative | liberal}
Function:
Set the label retention mode; the no operation will restore the default value.
Default:
Liberal
Command Mode: