PLANET XGS3-24042 - Manual (Page 836)

44-111
g_limit：<1-65535>, max number of groups joined.
s_limit：<1-65535>, max number of source entries in each group, consisting of include source and
exclude source.
Command mode:
Global Mode.
Default:
Maximum 50 groups by default, with each group capable with 40 source entries.
Usage Guide:
When number of joined group reaches the limit, new group requesting for
joining in will be rejected for preventing hostile attacks. To use this command, IGMP snooping must
be enabled on VLAN. The “no” form of this command restores the default other than set to “no limit”.
For the safety considerations, this command will not be configured to “no limit”. It is recommended
to use default value and if layer 3 IGMP is in operation, please make this configuration in
accordance with the IGMP configuration as possible.
Example:
Switch(config)#ip igmp snooping vlan 2 limit group 300
44.10.12 ip igmp snooping vlan mrouter-port interface
Command:
ip igmp snooping vlan <vlan-id> mrouter-port interface [ | ]
no ip igmp snooping vlan <vlan-id> mrouter-port interface [ | ]
Function:
Configure static mrouter port of VLAN. The no form of the command cancels this configuration.
Parameter:
vlan-id: ranging between <1-4094>
ehternet: Name of Ethernet port
ifname: Name of interface
port-channel: Port aggregation
Command Mode:
Global mode
Default:
No static mrouter port on VLAN by default.
Usage Guide:
When a port is a static mrouter port while also a dynamic mrouter port, it should be taken as a static