Chapter 75 commands for mpls, 1 mpls egress-ttl, Chapter 75 commands for mpls -4 – PLANET XGS3-24042 User Manual
Page 1174: Mpls egress
75-4
Admin and configuration mode
Usage Guide:
This command is used to debug, it is supposed to be used with the help of the technical support.
Example：
Show the statistics of CPU receiving ARP packets.
Switch#show cpu-rx protocol arp
Type Rate-limit TotPkts CurState
arp 500 3 allowed
Chapter 75 Commands for MPLS
75.1 mpls egress-ttl
Command:
mpls egress-ttl <0-255>
no mpls egress-ttl
Function:
Set the TTL value of IP messages through the egress LSR of LSP; the no operation will cancel the
configured value.
Parameters:
<0-255>: the TTL value.
Command Mode:
Global Mode
Usage Guide:
The egress-ttl configuration of the LSR will be the TTL of all IP messages forwarded through this
egress LSR.
Example:
Set the egress TTL as 45.
Switch#config terminal
Switch(config)#mpls egress-ttl 45
Related Commands:
mpls ingress-ttl