PLANET XGS3-24042 - Manual (Page 1084)

61-7
Priority is 100
Advertisement interval is 300 centisec
Preempt mode is TRUE
Circuit failover interface Vlan2, Priority Delta 10, Status UP
Display Explanation
State State.
Virtual IPv6 Virtual IPv6 address.
Interface Interface name.
Priority Priority.
Advertisement interval The interval of VRRPv3 advertisement messages.
Preempt Preempt mode.
Circuit failover interface Monitor interface information.
61.10 virtual-ipv6 interface
Command:
virtual-ipv6 <ipv6-address> interface {Vlan <ID>| IFNAME}
no virtual-ipv6 interface
Function:
Configure the virtual IPv6 address and interface of VRRPv3.
Parameters:
<ipv6-address>is the virtual IPv6 address, which has to be an IPv6 local link address.
{Vlan <ID>| IFNAME} is the interface name.
Command Mode:
VRRPv3 Protocol Mode.
Default:
There is no configuration by default.
Usage Guide:
This command is used to add an IPv6 address and interface to an existing backup group. The no
operation of this command will delete the virtual IPv6 address and interface of the specified backup
group. The virtual IPv6 address is the link local unicast address. There can only be one virtual IPv6
address in a backup group. In order to avoid the fault of returning physical MAC address when Ping
virtual IPv6 address, it is regulated that the virtual IPv6 address should not be the real IPv6 address
of the interface. Thus, the interfaces of all VRRPv3 backup groups are Backup by default, and need
to select a Master within the backup groups.