PLANET XGS3-24042 - Manual (Page 721)

41-13
show bfd neighbor [[|] [details]]
Function:
Show BFD neighbor in switch.
Parameter:
specifies the shown neighbor shown of IPv6 addres, specifies the
shown neighbor of IPv4 address, IP address refers to remote IP address, details shows the detail
information of neighbor.
Command Mode:
Admin mode and configuration mode
Usage Guide:
Show BFD neighbor in switch.
Example:
Check the relevant information of BFD neighbor.
s5#show bfd neighbor 50.1.1.1 details
OurAddr NeighAddr LD/RD Detec Int(ms) State Interface
50.1.1.5 50.1.1.1 1/1 2000 Up 3050
Local Diag: 0, Poll bit: 0
MinTx Int: 400(ms), MinRx Int: 400(ms), Multiplier: 5
Received MinRxInt: 400(ms), Received MinTxInt: 400(ms), Received Multiplier: 5
Local Act Trans Int: 400(ms), Remote Act Trans Int: 400(ms)
Local Act Detec Int: 2000(ms)
Registered protocols: RIP
Echo state: Disable, Echo Detec Int(ms): 2000
Multi Hop: No, Vrf Id: 0
Recv Ctl Pkt Num: 631, Send Ctl Pkt Num: 630
Recv Echo Pkt Num: 0, Send Echo Pkt Num: 0
Last packet: Version: 1 - Diagnostic: 0
Poll bit: 0 - Final bit: 0
Multiplier: 5 - Length: 24
My Discr: 1 - Your Discr: 1
Min tx interval: 400(ms) - Min rx interval: 400(ms)
Min Echo interval: 400(ms)