PLANET XGS3-24042 - Manual (Page 116)

XGS3 Command Guide
3-116
members to manually added ones to keep them.
Command Mode:
Global Mode.
Usage Guide:
Execute this command on a switch to change automatically added members to manually added ones.
Example:
change automatically added members to manually added ones.
Switch(config)#cluster member auto-to-user
3.9 cluster reset member
Command:
cluster reset member [id | mac-address ]
Function:
In the commander switch, this command can be used to reset the member switch.
Parameter:
member-id: ranging from 1 to 128. Use hyphen “-” or semicolon “;” to specify more than one member; if no value is
provided, it means to reboot all member switches.
Default:
Boot all member switches.
Command mode:
Admin Mode.
Instructions:
In the commander switch, users can use this command to reset a member switch. If this command is executed in a
non-commander switch, an error will be displayed.
Example:
In the commander switch, reset the member switch 1.
Switch#cluster reset member 1
3.10 cluster run
Command:
cluster run [key ][ vid ]
no cluster run
Function:
Enable cluster function; the “no cluster run” command disables cluster function.