PLANET XGS3-24042 - Manual (Page 704)

39-8
Switch# show interface tunnel 1
Tunnel1 is up, line protocol is up, dev index is 8001
Device flag 0x81(UP NOARP)
IPv4 address is:
(NULL)
VRF Bind: Not Bind
39.11 tunnel destination
Command:
tunnel destination { | }
no tunnel destination
Function:
Configure the destination address (IPv6 or IPv4 address) for GRE tunnel.
Parameter:
<ipv6-address> is the IPv6 address, is the IPv4 address.
Command mode:
Tunnel interface configuration mode.
Usage Guide:
Configure the destination address (IPv6 or IPv4 address) for GRE tunnel.
Example:
Configure the destination IPv4 address for GRE tunnel.
Switch(config)# interface tunnel 1
Switch(config-if-tunnel1)#tunnel destination 60.0.0.3
39.12 tunnel mode gre ip
Command:
tunnel mode gre ip
no tunnel mode
Function:
Configure the tunnel mode as GREv4, after data packets are encapsulated with GREv4, it has an
IPv4 packet head and pass the IPv4 network.
Command mode:
Tunnel interface configuration mode.