PLANET XGS3-24042 - Manual (Page 1161)

72-17
When the user finishes a set of configuration and needs to verify the configuration, show
running-config command can be used to display the current active parameters.
Example:
Switch#show running-config
72.18 show startup-config
Command:
show startup-config
Function:
Display the switch parameter configurations written into the Flash memory at the current operation;
those are usually also the configuration files used for the next power-up.
Default:
If the configuration parameters read from the Flash are the same as the default operating parameter,
nothing will be displayed.
Command mode:
Admin Mode
Usage Guide:
The show running-config command differs from show startup-config in that when the user
finishes a set of configurations, show running-config displays the added-on configurations whilst
show startup-config won’t display any configurations. However, if write command is executed to
save the active configuration to the Flash memory, the displays of show running-config and show
startup-config will be the same.
72.19 show switchport interface
Command:
show switchport interface [ethernet ]
Function:
Show the VLAN port mode, VLAN number and Trunk port messages of the VLAN port mode on the
switch.
Parameter:
is the port number.
Command mode: