3 isolate-port apply, Isolate, Port apply – PLANET XGS3-24042 User Manual
Page 142
XGS3 Command Guide
5-142
which will be able to communicate will ports in that group normally. If the ports removed from the group still belong to
another port isolation group, they will remain isolated from the ports in that group. If an Ethernet port is a member of
a convergence group, it should not be added into a port isolation group, and vice versa, a member of a port isolation
group should not be added into an aggregation group. But one port can be a member of one or more port isolation
groups.
Parameters:
specified name, create one; ethernet means that the ports to be isolated is Ethernet ones, followed by a list of
Ethernet ports, supporting symbols like ”;” and ”-”. For example: “ethernet 1/1;3;4-7;8”
interface, such as e1/0/1. If users use interface name, the parameter of ethernet will not be required.
Command Mode:
Global Mode.
Usage Guide:
Users can add Ethernet ports into or remove them from a port isolation group according to their requirements. When
an Ethernet port is a member of more than one port isolate group, it will be isolated from every port of all groups it
belongs to.
Example:
Add Ethernet ports 1/0/1-2 and 1/0/5 into a port isolation group named as ”test”.
Switch(config)#isolate-port group test switchport interface ethernet 1/0/1-2; 1/0/5
5.3 isolate-port apply
Command:
isolate-port apply [
Function:
This command will apply the port isolation configuration to isolate layer-2 flows, layer-3 flows or all flows.
Parameters:
<l2|l3|all> the flow to be isolated, l2 means isolating layer-2 flows, l3 means isolating layer-3 flows, all means
isolating all flows.
Command Mode:
Global Mode.
Default:
Isolate all flows.
Usage Guide:
User can apply the port isolation configuration to isolate layer-2 flows, layer-3 flows or all flows according to their
requirements.
Example:
Only apply port isolation to layer-2 flows on the switch.