PLANET XGS3-24042 - Manual (Page 1151)

72-7
Port mode
Default:
Do not include the sequence-number.
Usage Guide:
Use logging command to configure the loghost before this command is set.
Example:
Open the loghost sequence-number.
Switch(config)# logging loghost sequence-number
72.7 ping
Command:
ping [[src ] { | host }]
Function:
Issue ICMP request to remote devices, check whether the remote device can be reached by the
switch.
Parameters:
<source-address> is the source IP address where the ping command is issued, with IP address in
dotted decimal format. <destination-address> is the target IP address of the ping command, with
IP address in dotted decimal format. > is the target host name of the ping command,
which should not exceed 64 characters.
Default:
5 ICMP echo requests will be sent. The default packet size and time out is 56 bytes and 2 seconds.
Command Mode:
Admin mode
Usage Guide:
When the ping command is entered without any parameters, interactive configuration mode will be
invoked. And ping parameters can be entered interactively.
Example:
Example 1:
To ping with default parameters.
Switch#ping 10.1.128.160
Type ^c to abort.
Sending 5 56-byte ICMP Echos to 10.1.128.160, timeout is 2 seconds.
...!!