PLANET XGS3-24042 - Manual (Page 1012)

52-10
command deletes the key for RADIUS server.
Parameters:
is a key string for RADIUS server, up to 16 characters are allowed.
Command mode:
Global Mode
Usage Guide:
The key is used in the encrypted communication between the switch and the specified RADIUS
server. The key set must be the same as the RADIUS server set, otherwise, proper RADIUS
authentication and accounting will not perform properly.
Example:
Setting the RADIUS authentication key to be “test”.
Switch(config)#radius-server key test
52.15 radius-server retransmit
Command:
radius-server retransmit <retries>
no radius-server retransmit
Function:
Configures the re-transmission times for RADIUS authentication packets; the “no radius-server
retransmit” command restores the default setting.
Parameters:
is a retransmission times for RADIUS server, the valid range is 0 to 100.
Command mode:
Global Mode
Default:
The default value is 3 times.
Usage Guide:
This command specifies the retransmission time for a packet without a RADIUS server response
after the switch sends the packet to the RADIUS server. If authentication information is missing from
the authentication server, AAA authentication request will need to be re-transmitted to the
authentication server. If AAA request retransmission count reaches the retransmission time
threshold without the server responding, the server will be considered to as not work, the switch
sets the server as invalid.
Example:
Setting the RADIUS authentication packet retransmission time to five times.