PLANET XGS3-24042 - Manual (Page 153)

XGS3 Command Guide
7-153
default.
Command Mode:
Global Configuration Mode.
Default:
10 seconds by default.
Usage Guide:
Interval for hello messages can be configured only if ULDP is enabled globally, its value limited between 5 and 100
seconds.
Example:
To configure the interval of Hello messages to be 12 seconds.
Switch(config)# uldp hello-interval 12
7.11 uldp manual-shutdown
Command:
uldp manual-shutdown
no uldp manual-shutdown
Function:
To configure ULDP to work in manual shutdown mode. The no command will restore the automatic mode.
Command Mode:
Global Configuration Mode.
Default:
Auto mode.
Usage Guide:
This command can be issued only if ULDP has been enabled globally.
Example:
To enable manual shutdown globally.
Switch(config)# uldp manual-shutdown
7.12 uldp reset
Command:
uldp reset
Function:
To reset the port when ULDP is shutdown.
Command Mode: