PLANET XGS3-24042 - Manual (Page 874)

45-19
no debug ipv6 pim timer joinprune ot
no debug ipv6 pim timer joinprune plt
no debug ipv6 pim timer joinprune ppt
no debug ipv6 pim timer joinprune pt
no debug ipv6 pim timer joinprune
no debug ipv6 pim timer register rst
no debug ipv6 pim timer register
no debug ipv6 pim timer
Function:
Enable or Disable each PIM timer.
Default:
Disabled
Command Mode:
Admin Mode.
Usage Guide:
Enable the specified timer’s debug information.
Example:
Switch# debug ipv6 pim timer assert
45.3.10 ipv6 mroute
Command:
ipv6 mroute <X:X::X:X> <X:X::X:X> <ifname> <.ifname>
no ipv6 mroute <X:X::X:X> <X:X::X:X> [<ifname> <.ifname>]
Function:
To configure static multicast entry. This no command deletes some static multicast entries or some
egress interfaces.
Parameter:
are the source address and group address of multicast.
<ifname> <.ifname>, the first one is ingress interface, follow is egress interface.
Command Mode:
Global Mode.
Usage Guide:
The <ifname> should be valid VLAN interfaces. The multicast data flow will not be forwarded
unless PIM is configured on the egress interface and the interface is UP. If the state of the interface
is not UP, or PIM is not configured, or RPF is not valid, the multicast data flow will not be fordwarded.
To removed the specified multicast routing entry. If all the egress interfaces are specified, or no