22 ip pim multicast-routing, 23 ip pim neighbor-filter, 22 ip pim multicast-routing -32 – PLANET XGS3-24042 User Manual
Page 757: 23 ip pim neighbor-filter -32
44-32
44.3.22 ip pim multicast-routing
Command:
ip pim multicast-routing
no ip pim multicast-routing
Function:
Enable PIM-SM globally. The “no ip pim multicast-routing” command disables PIM-SM globally.
Default:
Disabled PIM-SM
Command Mode:
Global Mode
Usage Guide:
Enable PIM-SM globally. The interface must enable PIM-SM to have PIM-SM work
Example:
Enable PIM-SM globally.
Switch (config)#ip pim multicast-routing
Switch (config)#
44.3.23 ip pim neighbor-filter
Command:
ip pim neighbor-filter <list-number>
no ip pim neighbor-filter <list-number>
Function:
Configure the neighbor access-list. If filtered by the lists and connections with neighbors are created,
this connections are cut off immediately. If no connection is created, this connection can’t be
created.
Parameter:
<list-number>: <list-number> is the simple access-list number, it ranges from 1 to 99
Default:
No neighbor filter configuration.
Command Mode:
Interface Configuration Mode
Usage Guide:
ACL’s default is DENY. If configuring access-list 1, access-list 1’s default is deny. In the following
example, if “permit any” is not configured, deny 10.1.4.10 0.0.0.255 is the same as deny any.
Example: