PLANET XGS3-24042 - Manual (Page 1023)

54-2
Port Configuration Mode.
Default:
IPv6 security RA function is disabled by default.
Usage Guide:
Only after globally enabling the security RA function, can the security RA on a port be enabled.
Globally disabling security RA will clear all the configured security RA ports.
Example:
Enable IPv6 security RA on a port.
Switch(Config-If-Ethernet1/0/2)#ipv6 security-ra enable
54.3 show ipv6 security-ra
Command:
show ipv6 security-ra [interface ]
Function:
Display all the interfaces with IPv6 RA function enabled.
Parameters:
No parameter will display all distrust ports, entering a parameter will display the corresponding
distrust port.
Command Mode:
Admin and Configuration Mode.
Example:
Switch# show ipv6 security-ra
IPv6 security ra config and state information in the switch
Global IPv6 Security RA State: Enable
Ethernet1/0/1
IPv6 Security RA State: Yes
Ethernet1/0/3
IPv6 Security RA State: Yes
54.4 debug ipv6 security-ra
Command:
debug ipv6 security-ra
no debug ipv6 security-ra