PLANET XGS3-24042 - Manual (Page 738)

44-13
Disabled PIM-SM
Command Mode:
Global Mode
Usage Guide:
Enable PIM-SM globally. The interface must enable PIM-SM to have PIM-SM work
Example:
Enable PIM-SM globally.
Switch (config)#ip pim multicast-routing
44.2.11 ip pim neighbor-filter
Command:
ip pim neighbor-filter <list-number>
no ip pim neighbor-filter <list-number>
Function:
Configure the neighbore access-list. If filtered by the lists and connections with neighbors are
created, this connections are cut off immediately. If no connection is created, this conncetion can’t
be created.
Parameter:
<list-number>: <list-number> is the simple access-list number, it ranges from 1 to 99
Default:
No neighbor filter configuration.
Command Mode:
Interface Configuration Mode
Usage Guide:
ACL’s default is DENY. If configuring access-list 1,access-list 1’s default is deny. In the following
example, if “permit any-source” is not configured, deny 10.1.4.10 0.0.0.255 is the same as deny
any-source.
Example:
Configure VLAN’s filtering rules of pim neighbors.
Switch #show ip pim neighbor
Neighbor Interface Uptime/Expires Ver DR
Address Priority/Mode
10.1.4.10 Vlan1 02:30:30/00:01:41 v2 4294967294 / DR
Switch (Config-if-Vlan1)#ip pim neighbor-filter 2
Switch (config)#access-list 2 deny 10.1.4.10 0.0.0.255
Switch (config)#access-list 2 permit any-source