PLANET XGS3-24042 - Manual (Page 831)

44-106
Admin Configuration Mode
Usage Guide:
Use show command to check the deleted mrouter port of the specific VLAN.
Example:
Delete mrouter port in vlan 1.
Switch# clear ip igmp snooping vlan 1 mrouter-port
Relative Command:
show ip igmp snooping mrouter-port
44.10.3 debug igmp snooping
all/packet/event/timer/mfc
Command:
debug igmp snooping all/packet/event/timer/mfc
no debug igmp snooping all/packet/event/timer/mfc
Function:
Enable the IGMP Snooping switch of the switch; the “no debug igmp snooping
all/packet/event/timer/mfc” disables the debugging switch.
Command Mode:
Admin Mode
Default:
IGMP Snooping debugging switch is disabled on the switch by default.
Usage Guide:
The command is used for enable the IGMP Snooping debugging switch of the switch, switch IGMP
data packet message can be shown with “packet” parameter, event message with “event”, timer
message with “time”, downsending hardware entries message with “mfc”, and all debugging
messages with “all”.
44.10.4 ip igmp snooping
Command:
ip igmp snooping
no ip igmp snooping
Function:
Enable the IGMP Snooping function; the “no ip igmp snooping” command disables this function.
Command mode: