PLANET XGS3-24042 - Manual (Page 1206)

76-24
Usage Guide:
LDP can discover its neighbors through multicast Hello messages or specify one via the
“targeted-peer” command. Implementing this command will enable the multicast hello based
neighbor discovery. Implementing the no operation will stop sending multicast Hello messages, so
that the only way to discover neighbors is “targeted-peer”. Configure to sending and receiving
multicast hello messages globally, and enumerate all interfaces. If this attribute is already
configured on the interface, the global configuration will be ignored, otherwise, the global one will
take effect.
Example:
Switch(config)#router ldp
Switch(config-router)#multicast-hellos
76.38 propagate-release
Command:
propagate-release
no propagate-release
Function:
Configure to propagate the label release to neighbors; the no operation will do the opposite.
Default:
Disabled.
Command Mode:
LDP Protocol Configuration Mode.
Usage Guide:
If the label is expired, the switch won’t send it to the upstream, unless this command is enabled.
Example:
Switch(config)#router ldp
Switch(config-router)#propagate-release
76.39 request-retry
Command:
request-retry
no request-retry
Function: