PLANET XGS3-24042 - Manual (Page 1008)

52-6
Global Mode.
Usage guide:
The source IP address must belongs to one of the IP interface of the switch, otherwise an failure
message of binding IP address will be returned when the switch send RADIUS packet. We suggest
using the IP address of loopback interface as source IP address, it avoids that the packets from
RADIUS server are dropped when the interface link-down.
Example:
Configure the source ip address of RADIUS packet as 192.168.2.254.
Switch#radius nas-ipv4 192.168.2.254
52.10 radius nas-ipv6
Command:
radius nas-ipv6
no radius nas-ipv6
Function:
Configure the source IPv6 address for RADIUS packet sent by the switch. The no command deletes
the configuration.
Parameter:
is the source IPv6 address of the RADIUS packet, it must be a valid unicast IPv6
address.
Default:
No specific source IPv6 address for RADIUS packet is configured, the IPv6 address of the interface
from which the RADIUS packets are sent is used as source IPv6 address of RADIUS packet.
Command mode:
Global Mode.
Usage guide:
The source IPv6 address must belongs to one of the IPv6 interface of the switch, otherwise a failure
message of binding IPv6 address will be returned when the switch send RADIUS packet. We
suggest using the IPv6 address of loopback interface as source IPv6 address, it avoids that the
packets from RADIUS server are dropped when the interface link-down.
Example:
Configure the source ipv6 address of RADIUS packet as 2001:da8:456::1.
Switch#radius nas-ipv6 2001:da8:456::1