7 commands for dvmrp, 1 debug dvmrp, Ommands for – PLANET XGS3-24042 User Manual

Page 801: Dvmrp -76, 1 debug dvmrp -76

44-76

work with DVMRP.

3. Access-list can’t used the lists created by ip access-list, but the lists created by access-list.

4. Users can execute this command first and then configure the corresponding acl; or delete

corresponding acl in the bondage. After the bondage, only command no ip pim ssm can release the

bondage.

5. If ssm is needed, this command should be configured at the related edge route. For example, the

local switch with IGMP (must) and multicast source DR or RP (at least one of the two) configure this

command, the middle switch need only enable PIM-SM.

Example:

Configure the switch to enable PIM-SSM, the group’s range is what is specified by access-list 23.

Switch (config)#ip multicast ssm range 23

44.7 Commands for DVMRP

44.7.1 debug dvmrp

Command:

[probe[probe-timer|neighbor-expiry-timer]|

prune[prune-expiry-timer|prune-retx-timer|graft-retx-timer]|route[report-timer|flash-upd-time

[in|out | prune [in|out] graft [in|out] | graft-ack [in|out] |in|out]]|all]

no debug dvmrp [events[neighbor|packet|igmp|kernel|prune [detail]

|route]|nsm|mfc|mib|timer[probe[probe-timer|neighbor-expiry-timer]|prune[prune-expiry-tim

graft [in|out] | graft-ack [in|out] |in|out]]|all]

Function:

Display DVMRP protocol debugging message; the “no debug dvmrp

[probe[probe-timer|neighbor-expiry-timer]|prune[prune-expiry-timer|prune-retx-timer|graft-re

[in|out] |in|out]]|all]” command disenables this debugging switch.

Default:

Disabled

Command Mode:

This manual is related to the following products: