PLANET XGS3-24042 - Manual (Page 171)

9-17
port-group <port-group-number>
no port-group <port-group-number>
Function:
Creates a port group. The no command deletes that group.
Parameters:
> is the group number of a port channel from 1 to 128.
Default:
There is no port-group.
Command mode:
Global Mode
Example:
Creating a port group.
Switch(config)# port-group 1
Delete a port group.
Switch(config)#no port-group 1
9.8 port-group mode
Command:
port-group mode {active|passive|on}
no port-group
Function:
Add a physical port to port channel, the no operation removes specified port from the port channel.
Parameters:
is the group number of port channel, from 1 to 128;
active enables LACP on the port and sets it in Active mode;
passive enables LACP on the port and sets it in Passive mode; on forces the port to join a port
channel without enabling LACP.
Command mode:
Port Mode.
Default:
Switch ports do not belong to a port channel by default; LACP not enabled by default.
Usage Guide:
If the specified port group does not exist, then print a error message. All ports in a port group must
be added in the same mode, i.e., all ports use the mode used by the first port added. Adding a port