PLANET XGS3-24042 - Manual (Page 352)

19-198
19.2.38 tunnel source
Command:
tunnel source {<ipaddress> | | }
no tunnel source
Function:
Configure tunnel source.
Parameter:
is the IPv4 address of tunnel source, must be the unicast address; is
the IPv6 address of tunnel source; means the tunnel source address is the IPv4
address of the interface .
Command Mode:
Tunnel Configuration Mode.
Default Situation:
There is no IPv4/IPv6 address and interface name of tunnel source.
Usage Guide:
Set the source IPv4/IPv6 address or specify an interface name of the tunnel source address to
configure the tunnel.
Example:
Configure tunnel source IPv4 address 202.89.176.6.
Switch(Config-if-Tunnel1)#tunnel source 202.89.176.6
19.2.39 tunnel destination
Command: .
tunnel destination
no tunnel destination
Function:
Configure the IPv4/IPv6 address of the tunnel destination.
Parameter:
is the IPv4 address of tunnel destination, is the IPv6 address of
tunnel destination.
Command Mode:
Tunnel Configuration Mode.
Default Situation:
There is no IPv4/IPv6 address of tunnel destination.
Usage Guide: