PLANET XGS3-24042 - Manual (Page 668)

37-307
Sending the community attributes.
Command Mode:
BGP route mode and address-family mode
Usage Guide:
The community attributes can be sent to the outside or not. By default of our company we set to
sending while the default in standard protocol is not sending. By configuring this attribute
community attributes will be carried when sending routing information’s to the neighbors, or else not.
Omission of the following choice will be equal to standard.
Example:
Switch(config-router)#no neighbor 10.1.1.66 send-community
Switch(config-router)#neighbor 10.1.1.66 send-community
37.72 neighbor shutdown
Command:
neighbor {|} shutdown
no neighbor {|} shutdown
Function:
Disconnect the neighbor connection. The “no neighbor {|} shutdown”
cancels this configuration
Parameter:
: Neighbor IP address
: Name of peer group
Default:
Not disconnecting.
Command Mode:
BGP route mode and address-family mode
Usage Guide:
Directly disconnect/connect to a peer (group) without canceling the neighbor configuration.
Example:
Switch(config-router)#neighbor 10.1.1.64 shutdown
37.73 neighbor soft-reconfiguration inbound
Command: