PLANET XGS3-24042 - Manual (Page 1107)

63-14
Configure the master port of ULPP group, the no command deletes the master port.
Parameter:
is the ID of ULPP group, range from 1 to 48.
Default:
There is no master port configured by default.
Command mode:
Port mode.
Usage Guide:
There is no sequence requirement for the master and slave port configuration in a group, but the
protective VLANs must be configured before the member ports. Each group has only one master
port, if the master port exists, then the configuration fail.
Example:
Configure the master port of ULPP group.
Switch(config)# interface ethernet 1/0/1
Switch(config-If-Ethernet1/0/1)# ulpp group 20 master
63.25 ulpp group slave
Command:
ulpp group slave
no ulpp group slave
Function:
Configure the slave port of ULPP group, the no command deletes the slave port.
Parameter:
is the ID of ULPP group, the range from 1 to 48.
Default:
There is no slave port configured by default.
Command mode:
Port mode.
Usage Guide:
There is no sequence requirement for the master and slave port configuration in a group, but the
protective VLANs must be configured before the member ports. Each group has only one slave port,
if the slave port exists, then the configuration is fail.
Example:
Configure the slave port of ULPP group.
Example: