PLANET XGS3-24042 - Manual (Page 920)

45-65
Command:
ipv6 mld version
no ipv6 mld version
Function:
Configure the version of the MLD protocol running on the interface; the “no ipv6 mld version”
command restores the manually configured version to the default one.
Parameter:
is the version number of the MLD protocol, with a valid range of 1-2.
Default:
2 by default
Command Mode:
Interface Configuration Mode
Usage Guide:
While there is routers still not upgraded to version 2 of MLD protocol on the subnet connected, the
interface should be configured to corresponding version.
Example:
Configure the MLD version to 2.
Swith(config)#interface vlan 1
Swith(config-if-vlan1)#ipv6 mld version 2
45.7.15 show ipv6 mld groups
Command:
show ipv6 mld groups [{}]
Function:
Display the MLD group information.
Parameter:
is the name of the interface. Display the MLD group information. is the
group address. Display the specified group information.
Default:
Do not display
Command Mode:
Admin Mode
Example:
Switch#sh ipv6 mld group
MLD Connected Group Membership
Group Address Interface Uptime Expires