PLANET XGS3-24042 - Manual (Page 482)

31-121
31.13 match tag
Command:
match tag <tag-val >
no match tag [<tag-val >]
Function:
Configure to matching with the tag domain of the OSPF routing message. The “no match tag
[<tag-val >]” deletes this configuration.
Parameter:
<tag-val > is the tag value, ranging between 0～4294967295.
Command Mode:
route-map mode
Usage Guide:
This command matches according to the tag value in the OSPF route. If the matching succeeded,
then the “permit” or “deny” action in the route-map is performed.
Example:
Switch#config terminal
Switch(config)#route-map r1 permit 5
Switch(config-route-map)#match tag 60
31.14 route-map
Command:
route-map {deny | permit}
no route-map [{deny | permit} ]
Function:
Configure the route-map and entering the route-map mode. The “no route-map
[{deny | permit} ]” command deletes route-map.
Parameter:
is the name of route-map, permit sets route-map matching mode to permit mode,
deny sets route-map matching mode to permit mode （set sub will not be executed under this mode）,
is the route-map sequence number, ranging between 1～65535.
Command Mode:
Global Mode
Usage Guide:
A route-map may consist of several nodes each of which is a check unit. The check sequence