PLANET XGS3-24042 - Manual (Page 686)

37-325
Admin and configuration mode
Usage Guide:
Display detailed messages of all neighbors by this command without parameters. Specifying IP
address will show the detailed information of the neighbors with specified IP address. The
advertised-routes 、 received prefix-filter 、 received routes、 routes parameters will respectively
displays the routes broadcast on local side, the received prefix filter, received routes (soft
reconfiguration enabled) and the routing message from specific neighbor.
Example:
Switch#sh ip bgp neighbor
BGP neighbor is 10.1.1.66, remote AS 200, local AS 100, external link
BGP version 4, remote router ID 11.1.1.100
BGP state = Established, up for 00:13:43
Last read 00:13:43, hold time is 240, keep alive interval is 60 seconds
Neighbor capabilities:
Route refresh: advertised and received (old and new)
Address family IPv4 Unicast: advertised and received
Received 17 messages, 0 notifications, 0 in queue
Sent 17 messages, 0 notifications, 0 in queue
Route refresh request: received 0, sent 0
Minimum time between advertisement runs is 30 seconds
For address family: IPv4 Unicast
BGP table version 2, neighbor version 2
Index 1, Offset 0, Mask 0x2
Community attribute sent to this neighbor (both)
0 accepted prefixes
1 announced prefixes
Connections established 7; dropped 6
37.97 show ip bgp paths
Command:
show ip bgp [] paths
Function:
Display the path message permitted by BGP.
Parameter: