PLANET XGS3-24042 - Manual (Page 587)

35-226
Hello due in 00:00:16
Neighbor Count is 0, Adjacent neighbor count is 0
35.58 show ip ospf neighbor
Command:
show ip ospf [] neighbor [{<neighbor_id> |all |detail [all] |interface <ifaddress>}]
Function:
Display the OSPF adjacent point messages.
Parameter:
is the process ID ranging between 0~65535
<neighbor_id> is the dotted decimal notation neighbor ID
all: Display messages of all neighbors
detail: Display detailed messages of all neighbors
<ifaddress> Interface IP address
Default:
Not displayed
Command Mode:
Admin and configuration mode
Usage Guide:
OSPF neighbor state can be checked by viewing the output of this command.
Example:
Switch#show ip ospf neighbor
OSPF process 0:
Neighbor ID Pri State Dead Time Address Interface
192.168.1.1 1 Full/Backup 00:00:32 6.1.1.1 Vlan1
192.168.1.3 1 Full/DR 00:00:36 20.1.1.3 Vlan2
192.168.1.3 1 Full/ - 00:00:30 20.1.1.3 VLINK2
Displayed information Explanation
Neighbor ID ID Neighbor ID
Priority Priority
State Neighbor relation state
Dead time Neighbor dead time
Address Interface Address
Interface Interface name