PLANET XGS3-24042 - Manual (Page 737)

44-12
Switch (Config -if-Vlan1)#ip pim hello-holdtime 10
Switch (Config -if-Vlan1)#
44.2.9 ip pim hello-interval
Command:
ip pim hello-interval < interval>
no ip pim hello-interval
Function:
Configure interface PIM-DM hello message interval; the “no ip pim hello-interval” restores default
value.
Parameter:
< interval> is interval of periodically transmitted PIM-DM hello message, value range from 1s to
18724s.
Default:
Default interval of periodically transmitted PIM-DM hello message as 30s.
Command Mode:
Interface Configuration Mode.
Usage Guide:
Hello message makes PIM-DM switch mutual location, and ensures neighborship. PIM-DM switch
announces existence itself by periodically transmitting hello messages to neighbors. If it doesn’t
receive hello messages from neighbors in regulation time, it confirms that the neighbors were lost.
Configuration time is not more than neighbor overtime.
Example:
Configure PIM-DM hello interval on interface vlan1.
Switch (config)#interface vlan1
Switch(Config-if-Vlan1)#ip pim hello-interval 20
44.2.10 ip pim multicast-routing
Command:
ip pim multicast-routing
no ip pim multicast-routing
Function:
Enable PIM-SM globally. The “no ip pim multicast-routing” command disables PIM-SM globally.
Default: