PLANET XGS3-24042 - Manual (Page 1200)

76-18
configuration will have no effect on it.
Example:
Set the neighbor hold-time as 220s:
Switch(config)#int vlan 9
Switch(Config-if-Vlan9)#ldp hold-time 220
Related Commands:
ldp hello-interval, hello-interval
76.29 ldp keepalive-interval
Command:
ldp keepalive-interval <interval-time>
no ldp keepalive-interval
Function:
Configure the interval between keep-alive messages; the no operation will restore the default value.
Parameters:
is the interval between keep-alive messages, ranging from 1 to 65535 seconds.
Default:
Use the global configuration.
Command Mode:
Interface Configuration Mode
Usage Guide:
LDP will send keepalive messages to each other for keeping the communication, if there is no data
after the creation of a TCP session. Implementing this command will set the interval of sending
keepalive messages. Please make sure the value is big enough to prevent too many keepalive
messages. Parameters different with the global configuration can be used when configuring the
interface.
Example:
Configure the keepalive-interval of the interface as 33s.
Switch(config)#int vlan 9
Switch(Config-if-Vlan9)#ldp keepalive-interval 33
Related Commands:
ldp keepalive-timeout, keepalive-timeout