PLANET XGS3-24042 - Manual (Page 97)

XGS3 Command Guide
1-97
Switch (config)#no snmp-server view readview
1.5 Commands for Switch Upgrade
1.5.1 copy（FTP）
Command:
copy [ascii | binary]
Function:
Download files to the FTP client.
Parameter:
is the location of the source files or directories to be copied;
is the destination address to which the files or directories to be copied; forms of and
vary depending on different locations of the files or directories.
ascii indicates the ASCII standard will be adopted;
binary indicates that the binary system will be adopted in the file transmission（default transmission method）.When
URL represents an FTP address, its form should be:
ftp://:@{|| }/,amongst is the
FTP user name, is the FTP user password,| is the IPv4 or IPv6 address of
the FTP server/client, is the name of the host mapping with the IPv6 address,it does not support the file
download and upload with hosts mapping with IPv4 addresses, is the name of the FTP upload/download
file.
Special keywords of the filename
Keywords Source or destination addresses
running-config Running configuration files
startup-config Startup configuration files
nos.img System files
nos.rom System startup files
Command Mode:
Admin Mode.
Usage Guide:
This command supports command line hints, namely if the user can enter commands in following forms: copy
ftp:// or copy ftp:// and press Enter, following hints will be provided by the system：
ftp server ip/ipv6 address [x.x.x.x]/[x:x::x:x] >
ftp username>
ftp password>