PLANET XGS3-24042 - Manual (Page 161)

8-7
When transmit delay is the default value and tx-interval is configured via some commands, transmit
delay will become one fourth of the latter, instead of the default 2.
Parameters:
<seconds>is the time interval, ranging from 1 to 8192 seconds.
Default:
The interval is 2 seconds by default.
Command Mode:
Global Mode.
Usage Guide:
When the messages are being sent continuously, a sending delay is set to prevent the Remote
information from being updated repeatedly due to sending messages simultaneously.
Example:
Set the delay of sending messages as 3 seconds.
Switch(config)# lldp transmit delay 3
8.12 lldp transmit optional tlv
Command:
lldp transmit optional tlv [portDesc] [sysName] [sysDesc] [sysCap]
no lldp transmit optional tlv
Function:
Configure the type of optional TLV of the port.
Parameters:
portDesc: the description of the port; sysName: the system name; sysDesc: The description of
the system; sysCap: the capability of the system.
Default:
The messages carry no optional TLV by default.
Command Mode:
Port Configuration Mode.
Usage Guide:
When configuring the optional TLV, each TLV can only appear once in a message, portDesc
optional TLV represents the name of local port; sysName optional TLV represents the name of local
system; sysDesc optional TLV represents the description of local system; sysCap optional TLV
represents the capability of local system.
Example:
Configure that port ethernet 1/0/5 of the switch carries portDesc and sysCap TLV.