PLANET XGS3-24042 - Manual (Page 762)

44-37
candidate RP information in order to compete RP router with other candidate RPs.Only this
command is configured, this switch is the RP candidate router.
Example:
Configure vlan1 as the sending interface of candidate RP announcing sending messages
Switch (config)# ip pim rp-candidate vlan1 100
44.3.30 ip pim rp-register-kat
Command:
ip pim rp-register-kat <vaule>
no ip pim rp-register-kat
Function:
This command is to configure the KAT (KeepAlive Timer) value of the RP (S, G) items, the unit is
second. The “no ip pim rp-register-kat” command restores the default value.
Parameter:
<vaule> is the timer value; it ranges from 1 to 65535s.
Default:
185s
Command Mode:
Global Mode
Usage Guide:
This command is to configure the RP’s keep alive time, during the keep alive time RP’s (S, G) item
will not be deleted because it hasn’t received REGISTER packets. If no new REGISTER packet is
received when the keep alive time is over, this item will be obsolete.
Example:
Configure the kat value of RP’s (S, G) item to 180s
Switch (config)#ip pim rp-register- kat 180
Switch (config)#
44.3.31 ip pim scope-border
Command:
ip pim scope-border [<1-99 >|<acl_name>]
no ip pim scope-border
Function:
To configure or delete management border of PIM.