PLANET XGS3-24042 - Manual (Page 1077)

60-16
Virtual IP Dummy IP address
Interface Interface Name
Priority Priority
Advertisement interval Timer interval
Preempt Preemptive mode
Circuit failover interface Interface Monitor information
60.11 virtual-ip
Commands:
virtual-ip <A.B.C.D>
no virtual-ip
Function:
Configures the VRRP dummy IP address.
Parameters:
<A.B.C.D> is the IP address in decimal format.
Default:
Not configured by default.
Command mode:
VRRP protocol configuration mode
Usage Guide:
This command adds a dummy IP address to an existing Standby cluster. The "no virtual-ip"
command removes the dummy IP address from the specified Standby cluster. Each Standby cluster
can have only one dummy IP. VRRP priority as 255 (not configure), virtual-ip and interface ip should
in the same segment.
Special Notice: When updating to the newest version from 5.2.0.0 or an older one, the original
VRRP command configuration can’t be restored. Please delete the original configuration with “no
router vrrp ”, and then reconfigure. Otherwise, problems like suspended tasks may happen.
Example:
Setting the backup dummy IP address to 10.1.1.1.
Switch(Config-Router-Vrrp)# virtual-ip 10.1.1.1