PLANET XGS3-24042 - Manual (Page 335)

19-181
Command:
ipv6 nd dad attempts
no ipv6 nd dad attempts
Function:
Set Neighbor Solicitation Message number sent in succession by interface when setting Duplicate
Address Detection.
Parameter:
<value> is the Neighbor Solicitation Message number sent in succession by Duplicate Address
Detection, and the value of <value> must be in 0-10, NO command restores to default value 1.
Command Mode:
Interface Configuration Mode
Default:
The default request message number is 1.
Usage Guide:
When configuring an IPv6 address, it is required to process IPv6 Duplicate Address Detection, this
command is used to configure the ND message number of Duplicate Address Detection to be sent,
value being 0 means no Duplicate Address Detection is executed.
Example:
The Neighbor Solicitation Message number sent in succession by interface when setting Duplicate
Address Detection is 3.
Switch(Config-if-Vlan1)# ipv6 nd dad attempts 3
19.2.16 ipv6 nd ns-interval
Command:
ipv6 nd ns-interval
no ipv6 nd ns-interval
Function:
Set the time interval of Neighbor Solicitation Message sent by the interface.
Parameter:
parameter <seconds> is the time interval of sending Neighbor Solicitation Message, <seconds>
value must be between 1-3600 seconds, no command restores the default value 1 second.
Command Mode:
Interface Configuration Mode
Default:
The default Request Message time interval is 1 second.
Default: