PLANET XGS3-24042 - Manual (Page 988)

49-6
Switch(Config-if-Vlan1)#no ipv6 nd dynamic maximum
49.9 mac-address query timeout
Command:
mac-address query timeout
Function:
Set the timeout value of querying dynamic MAC.
Parameter:
<seconds> is timeout value, in second, ranging from 30 to 300.
Default Settings:
Default value is 60 seconds.
Command Mode:
Global mode
Usage Guide:
After enabling the number limitation of MAC, users can use this command to configure the timeout
value of querying dynamic MAC. If the data traffic is very large, the timeout value can be shorter,
otherwise, it can be longer. Users can set it according to actual situation.
Examples:
Set the timeout value of quering dynamic MAC as 30 seconds.
Switch(config)#mac-address query timeout 30
49.10 show arp-dynamic count
Command:
show arp-dynamic count {(vlan <1-4096>)| interface ethernet }
Function:
Display the number of dynamic ARP of corresponding port and VLAN.
Parameters:
<vlan-id> is play the specified vlan ID.
is the name of layer-2 port.
Command Mode:
Admin and Configuration Mode.
Usage Guide:
Use this command to display the number of dynamic ARP of corresponding port and VLAN.